Why do kiwi bags?

First, prepare before kiwi bagging

First remove the deformed fruits, pests and diseases, small fruits, etc., and keep the stalks sturdy and well-developed young fruits. The young trees can be based on the strength of the fruiting mother branches. Each fruiting mother branch leaves 2 to 3 fruiting branches, each fruiting. Two to three fruits are left on the branches. As a result of weak and injured trees, the female branches should retain less or no fruits.

Second, the choice of kiwi bagging

The paper bag is preferably a single layer of beige thin waxy wood pulp paper bag, 15 to 18 cm long and 11 to 13 cm wide, with a slit in the middle of the upper mouth, iron wire on one side, and an opening of 2 to 4 cm on the lower corner. The paper bag must be waterproof. , Good ventilation, good toughness.

Third, kiwi bagging time

Kiwi bagging should start about 30 days after flowering, and it takes 10-15 days to finish the bagging. Bagging should be carried out after dew drying in the morning, or after the liquid medicine is dry. On sunny days, it is generally suitable between 9:00 am to 11:30 am and 4:00 pm to 6:30 pm, and it is not advisable to immediately bag after rain. If bagging is too early, it will easily damage the skin of the fruit stalk, which is not conducive to the development of young fruit. If the bagging is too late, the fruit surface will be rough, which will affect the bagging effect.

4. Spray medicine before kiwi bagging

The kiwi is sprayed with insecticide and fungicide in the whole garden before bagging. It can be sprayed with 2500 times solution of 20% anti-sweep, 2,000 times of 18%, or 2000 times of green kung fu, methyl tolbutin or carbendazim. Broad-spectrum fungicides, to control chafers, beetles, crickets, scale insects and other pests, and to prevent fruit rot, gray mold and other diseases. The use of highly toxic and highly residual pesticides and plant growth regulators is prohibited.

Five, kiwi bagging method

The paper bag can be placed in a damp place the night before bagging, so that the bag is softened, so as to help tighten the bag mouth.

When bagging, use one hand to open the mouth of the bag, and put the good young fruit into the bag from bottom to top. The other hand will fold the bag from the slit to a uniform fold, and use the wire on the side of the bag to fold the folds. Tight, the solitary fruit on the fruit branch can be directly tied to the fruit bearing fruiting branch, the clustered fruit is tied directly to the fruit stalk, and the folded fruit bag is lined on the fruit stalk. Fruit stalk. Check whether the bottom of the fruit bag is open. If the bottom of the bag is completely closed, use scissors to cut the opening of 2 to 4 cm. The mouth is tightly sealed. When bagging, the inside and the outside should be gentle, and the sagging or upright branches should be fixed in time to prevent the wind from blowing.

Note: If you encounter high temperature weather (temperature is higher than 38 ℃) after bagging, open the bottom of the bag to ventilate it to reduce the temperature inside the bag.

Management after kiwi bagging

1. Regularly inspect the growth of bagged fruits, investigate and record the growth of fruits and pests, and take corresponding countermeasures in time, and find that the broken bags are replaced in time.

2. If the weather is prolonged and dry, the temperature in the fruit bag is too high, which can easily cause the sunburn of the fruit. It should be balanced and timely irrigated. Pay attention to drainage in the rainy season to prevent roots.

3. Remove the fruit bag 7 days before harvest to improve the color of the fruit surface. In case of rainy weather, it is possible to postpone bag removal and postpone harvesting to avoid fruit surface pollution caused by rain.

Disclaimer: Some articles on this website are transferred from the Internet. If you have third party legal rights, please inform this website to deal with them. phone

cosmetic raw material

Cosmetic ingredients are too broad a range. Our industry is usually divided into: 1. Basic ingredients, water or oil The main basic ingredients of general skin care products are distilled water or purified water, oil is vegetable oil or animal oil or mineral oil, according to the form of oil: liquid oil, semi-solid fat, solid wax. 2. Added ingredients, functional ingredients or control and adjustment ingredients Functional ingredients are mainly moisturizing, whitening, anti-aging, acne and other effective ingredients, according to different processes, plants as extracts, other organisms as extracts. Control components are preservatives, antibacterial agents, thickeners, emulsifiers, flavors, pigments and so on. Preservatives ensure that the product will not rot and deteriorate, antibacterial agents ensure that the product will not be infected by fungi, thickener to adjust the viscosity and flow variation, emulsifier to determine the product evenly dispersed into another substance, essence and pigment to ensure the stability of product smell and color. So, I don't know if that's what you want to know? Or do you want to know the names, the structures, the properties of the various monomer components, and if you want to know about that you can go to the INCI directory and Cos Dna for details

cosmetics products,buy cosmetics products,cosmetics products for sale,best thrive cosmetics products

Shaanxi YXchuang Biotechnology Co., Ltd , https://www.peptidenootropic.com