Fungus tube planting Pleurotus ostreatus increased production
The oyster mushrooms cultivated in the bacteria bag will have a greatly reduced yield after the 2-3 mushrooms are produced, and if the temperature is raised, the quality will be lowered. How to cultivate a post-early mushroom that is equal or even higher than the yield of the former mushroom? The following is a simple and practical method - the method of breaking. Remove the bag of 2-3 mushrooms from the plastic bag, then scrape the old skin on the surface and soak it in 5% lime water. If the cartridge is dry, soak it in 1% saline for half a minute. Before soaking, make a through hole in the fungus tube to facilitate the salt water immersion, which will increase the yield. The fungus tube is cut into two sections from the middle, and the section is discharged upward into the trampoline or shallow groove. The section should be as flat as possible, the overall height should be 1-2 cm higher than the ground, and measures such as ridges should be taken around to prevent large water from entering. The gap between the broken tubes is filled with the debris of the bacteria and then filled. The section is covered with soil debris and grass ash, and the ratio is 1:1:2, and the thickness is about 1 cm. Spray a little water to wet and gently flatten it. The top layer is covered with a layer of microbial debris, which is about 1 cm thick. It is flattened after spraying a little water. It is necessary to use the mushroom pieces which are rarely found in the mushrooms to form crumbs. After maintaining the humidity for 4-5 days, spray the water again, and then manage it to the mushroom after the routine, which can increase the yield by more than l times. Disclaimer: Some articles on this website are transferred from the Internet. If legal rights of third parties are involved, please inform this website. phone Short range distance sensors from JRT combine highly precise measurement results with quick and reliable response. Short distance sensor module use single-transmit and single-receive measurement technology and can be used to measure a distance or monitor the slow moving objects. For the laser pointer distance measure, also called optical range sensor, can measure legth, width, depth. Laser rangefinder transducer with rxtx has been widely used to industries. Laser Distance Sensor Short Range,Short Range Sensors,Oem Laser Distance Sensor,Distance Sensor Laser Chengdu JRT Meter Technology Co., Ltd , https://www.infrareddistancesensor.com