All kinds of agricultural machinery have large traction resistance when working in the field. If the maintenance is not properly performed, the situation where the fixing bolts of the traction device suspension brackets are pulled off easily occurs. To extract broken bolts is not easy, a method of taking out the broken bolts is introduced for reference. ?? 1. First remove the broken bolt off the surface of the sludge, with the center of the cross-section of the center to death, and then use an electric drill fitted with a diameter of 6-8 mm drill hole in the cross section at the center of the hole, pay attention to the hole must Drill through. After the hole is drilled, the small drill bit is removed, and the drill bit with a diameter of 16 mm is replaced, and the hole of the broken bolt is further expanded and drilled. ?? 2. take the electrode diameter of 3.2 mm or less, the use of small and medium current in the broken bolt hole from the inside to the outside surfacing welding, the beginning of the surfacing site to take off the entire length of the bolt can be half. The arc should not be too long, so as not to break through the outer wall of the broken bolt. After surfacing to the upper end of the broken bolt, it is continued to build a cylindrical body with a diameter of 14-16 mm and a height of 8-10 mm. After the surfacing is completed, hammering the end face with a hand hammer will cause the broken bolt to vibrate in the axial direction. Since the heat generated by the arc and subsequent cooling, coupled with the vibration at this time, will make There is looseness between the broken bolt and the thread of the body. ? 4 ä»” ä»” 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4. ?? 5. After welding, cool, hot with a plum wrench around the nut back and forth twist, back and forth can also be twisted side tapping the nut with a small hammer, so you can remove the broken bolt. 6. After taking out the broken bolts, use the appropriate silk hammer to process the threads in the frame once to remove the rust and other impurities in the holes.
Multi Span Plastic Film Greenhouse
Arch greenhouse is a kind of economical greenhouse, which is welcomed by the users with graceful curve form and low cost. It has beautiful appearance, fluent visual, reasonable structure and good performance for keep temperature. It is economical greenhouse because of its relatively low manufacturing cost. It can be applied in most areas of China. Double membrane greenhouse is used more in north of China, while single film greenhouse is used more in southern region. It can get maximum sunlight when visible light is within the scope of 0.4 to 0.7 microns and form a thick envelope, which can effectively prevent heat loss and prevent the invasion of cold air. Adopting a double membrane can greatly improve heat preservation performance of the greenhouse and save operating cost. The top cover material is polyethylene lifelong anti-fog and anti-dipping film po-covering. The outer of it has the function of UV protection and the inner has the function of preventing from the sets of dew. According to the needs of customers, the sides of the greenhouse can be covered with polyethylene lifelong anti-fog and anti-dripping po-covering or polycarbonate hollow plate.
Multi Span Plastic Film Greenhouse,Pc Greenhouse,Pc Sheet Covering Greenhouse,Greenhouse Pc Board
JIANGSU SKYPLAN GREENHOUSE TECHNOLOGY CO.,LTD , https://www.skyplantgreenhouse.com